Menu' M08 First Load; Menu' 09 Stove Status; Menu' 10 Engineer Settings; Menu' 11 Dealer Settings (If Available) - L'Artistico GERICO 9 Instructions For Use Manual

13. MENU' M08 FIRST LOAD

This menu allows filling the feeding screw when first loading pellet into the relevant fuel tank.
This takes around 90 ".
Attention: this operation must be done only with the appliance switched off and only when the appliance is
switched on for the first time: after its installation. It should not be used at every daily ignition (unless the tank
and the auger are completely empty of pellets and the appliance fails to ignite due to lack of fuel).
IMPORTANT: after carrying out this operation, absolutely empty the brazier from any pellets that have fallen
inside; remember that the brazier must be completely clean and empty before each ignition / re-ignition, whether
the latter is done manually, or in the case of programmed ignitions with a chronothermostat, via the stand-by
function or remotely via the App (danger of explosion).
°
To load

14. MENU' 09 STOVE STATUS

The display scrolls the status of certain variables during the operation of the unit, as:
For fireplace hydro, the boiler water pressure (in bar, "b" on the display)
Operating time
Working power
Flue gas temperature (° C)
Number of revolutions of the fumes
°
Here are the results of the report are displayed on the screen:
STATE 0 = UNIT OFF
STATE 1 = UNIT IN LIGHTING
STATE 2 = UNIT IN WAIT PREHEAT
STATE 3 = UNIT IN FIRE ON
STATE 4 = UNIT IN WORK
STATE 5 = UNIT IN FIRE-POT CLEANING
STATE 6 = UNIT IN FINAL CLEANING
STATE 7 = UNIT IN WAIT COOLING STAND-BY
STATE 8 = UNIT IN ALARM IN PROGRESS
STATE 9 = UNIT IN MEMORY ALARM

15. MENU' 10 ENGINEER SETTINGS

This menu is under code and is reserved to a Technical Service

16. MENU' 11 DEALER SETTINGS (if available)

This menu is under code and is reserved to a Dealer
L'ARTISTICO SRL |
Until to....
90" – 89" – 88"...
Until to....
29
Cod. 40297 | Rev. 09 | 05/2021 |
EN