Electrolux DB52 Instruction Manual page 48

If the refrigerator makes
abnormal noises
Excessive moisture in
the drawer of fruits and
vegetables
Alarm sounding
Message from the
functions indicator
Panel/Keyboard does
nor accept command
Open door alarm does
not work
If Turbo Freezing or
Drink Express button is
touched, compressor
(motor) does not ON
immediatelly
Touching buttons the
beep is not sound. The
alarm TURBO FREEZING
/ DRINK EXPRESS DOES
NOT SOUND
Panel and lamps are
working, but refrigerator
does not cool
48
POSSIBLE CAUSES / CORRECTION
Refrigerator against the wall.
Refrigerator unleveled.
Noise by air circulation.
Food stored unpackaged.
Door open.
Mains voltage different from the
refrigerator's.
Power outage or voltage oscillation.
Failure of any of the refrigerator functions.
Locked panel.
Shopping function activated.
Freezer automatic defrost is in progress.
Compressor (motor) has just been ON.
Time selection of Turbo Frrezing or drink of
the Drink Express.
Power outage or voltage oscillation.
Refrigerator is operating in "Show Room"
mode, that is, demo mode.
Put it away from the wall, leaving 15 cm off.
Adjust the leveling feet as instructed,
leaving the refrigerator perfectly flated on
the floor.
It is a normal noise, characteristic of the air
flow in Frost Free refrigeration systems.
Package them properly.
Close the refrigerator/freezer door.
See item "Electrical Installation".
Disconnect plug from the outlet and
reconnect it.
Call the Electrolux Authorized Service.
Touch lock panel.
Disable Shopping function by the AUTO
CONTROL button.
Wait for the end defrost (approximately 30
minutes) and the selected function will be
executed as requested.
The compressor (motor), after OFF,
always wait a few minutes before turning
ON to allow the internal pressures of the
cooling system are stabilized. This avoids
overloading and premature wear of the
compressor, which is normal.
After toucing a button function selection,
there is a time of a few seconds (intended)
for the function to be activated. This is so
that you can visually confirm your choice
before the the function operation.
Disconnect plug from the outlet for 5
minutes and reconnect it.
Disconnect plug from the outlet, wait for 10
seconds and reconnect it.