Troubleshooting; Safety Information - Amplicomms TV3500 Manual

Troubleshooting

No sound
- Ensure that the mains adapter is fully pushed into the power outlet and that
its cable is properly connected to the DC IN connector on the base.
- Ensure that the headset ON. Either red or blue LED is steady on.
- The charge level of the headset battery may be too low. Put the headset on
the charging cradle for 2 hours.
- Ensure that the TV set, Hi-Fi system or audio device is switched ON and the
input source selection/connection is correct (AUX switch).
- The connected audio/video equipment may not be in playback mode. Start
playback on the equipment.
- The headset output level is set too low. Adjust the volume to a suitable level
with the remote control.
Distortion
- The headset may be too far away from the base. Move closer to it.
- The audio signal input level is too low/high. Increase/decrease the volume
from the audio source TV/Hifi.

Safety Information

Please read this operating instruction manual thoroughly.
Intended use
This device was developed to transmit audio signals from an audio source like
TV or HiFi device to a headset, using cordless transmission. Any other use is
considered unintended use. Unauthorised modification or reconstruction is not
permitted. Under no circumstances open the devices or complete any repair
work yourself.
Installation location and safety information
• Prevent excessive exposure to smoke, dust, vibration, chemicals, moisture,
heat and direct sunlight.
24