Amplicomms TV3500 Manual page 20

3.a. Using the analog audio cable.
Connect one side of the analog cable to the base and the other side to the
analog audio output TV/Hifi socket. You may have to purchase adaptor plugs if
your TV/Hifi output socket has no 3.5mm audio output (see drawings below).
Then on the base, move the switch (AUX) on position 2 = Analog input.
3.b Using the optical audio cable
Connect one side of the optical cable to the base and the other side to the TV
audio optical output.
Then on the base, move the switch (AUX) on position 1 = Optical input.
This connection offers a higher sound quality and a lower susceptibility to
electrical and magnetic interference.
Please make sure the optical TOSLINK digital audio cable does not get bent or
folded! Avoid tight bending radii.
3.c Using base microphone (only if no audio ouput on TV).
1. If your TV set does not have any audio jack, you should use the microphone
to pick up the signal. Put base close to your TV/Hifi lousdpeaker for better
signal pickup. Then on the base, move the switch (AUX) on position 3
=Microphone.
2. Please start with low volume on the TV. Adjust the TV volume level up
slowly so as to determine the suitable volume level. The position of the
base also has a decisive influence on the volume – please determine the
best position by experimentation.
Note : Adaptor plugs are not provided
20