Toto T20S Series Installation And Owner's Manual page 6

INSTALLATION PROCEDURE
Install the Spout
To Install Deck-Mounted models
To Install Wall-Mounted models
NOTE:
To Install Libella and Axiom Wall-Mounted models
To Install Helix Wall-Mounted models
4 5 6
4 5 6
- 10 -
INSTALLATION PROCEDURE
Connect the Spout to the Controller
1. Cut the hose if necessary. Make sure the cuts are square.
90°
TLE0150* & TLE0350*
2. Push the hose completely onto the outlet barb of the controller and secure it with the
hose clamp. Make sure that the hose and hose clamp are placed fully against the
controller.
Hose
Hose
clamp
TLE0150* & TLE0350*
3. Insert the sensor connector as shown. Listen for the "click" indicating a secure
connection.
Only EWATER+ models (TLE0250*)
Insert the blue light connector as shown. Listen for the "click" indicating a secure connection.
Sensor cable
Sensor cable
Pass the sensor cable through the
lower right side of the controller.
TLE0150* & TLE0350*
Only ECOPOWER models (TLE0350*)
If you haven't connected the backup battery, connect the backup battery connector to
the controller. Product will require 5 min. to initialize.
See "Install the controller" section.
4. AC and EWATER+ models
(TLE0150* & TLE0250*)
Insert the power plug.
90°
TLE0250*
Hose
Hose
clamp
TLE0250*
Sensor cable
Blue light
cable
Cables
Pass the cables through the lower
left side of the controller.
TLE0250*
- 11 -