Bounce Flash; Zoom: Setting The Flash Coverage; Low Battery Warning; C.fn: Setting Custom Functions - Godox V860IIIF Instruction Manual

Bounce Flash

By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
330°
● If the wall or ceiling is too far away, the bounced flash might
be too weak and result in underexposure.
● The wall or ceiling should be a plain, white color for high
reflectance. If the bounce surface is not white, a color cast
may appear in the picture.

ZOOM: Setting the Flash Coverage

The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 20mm to 200mm.
If you set the flash coverage manually, make sure it covers
the lens focal length so that the picture will not have a dark
periphery.
- 51 -
-7-120°
In Manual Zoom mode, press the
<ZOOM> button.
● Turn the Select Dial to change
the flash coverage.
● If < > is displayed, the flash
coverage will be set
automatically.

Low Battery Warning

If the battery power is low, < >
will appear and blink on the LCD
panel. Please replace the battery
immediately.

C.Fn: Setting Custom Functions

The following table lists the available and unavailable custom
functions of this flash.
C.Fn Custom Functions
Function
Custom
Function
Signs
m/ft Distance indicator
AF AF-assist beam
STBY Auto sleep setting
RX STBY Receiver auto power
off timer
SCAN Scan the spare channel
CH Channel setting
ID Wireless ID
BEEP Beeper
LIGHT Backlighting time
LCD LCD contrast ratio
1. Press<MENU> Button until C.Fn menu is displayed. The "Ver
x.x" in the top-right corner refers to the software version.
2. Select the Custom Function No.
● Turn the Select Dial to select the Custom Function No.
3. Change the Setting.
● Press Set Button and the Setting No. blinks.
● Turn the Select Dial to set the desired number. Pressing Set
Button will confirm the settings.
● After you set the Custom Function and press <MENU> button,
the camera will be ready to shoot.
4. In the C.Fn states, long press the "Clear"button for 2 seconds
until "OK"is displayed on the panel, which means the values in
C.Fn can be reset.
Setting Settings & Description
No.
m
m
feet
ft
ON
ON
OFF
OFF
ON
ON
OFF
OFF
60min
60min
30min
30min
OFF
OFF
Start to find the spare
START
channel
Choose channels
01-32
from 01-32
Off
OFF
Choose any figure
01-99
from 01-99
ON
ON
OFF
OFF
Off in 12 sec.
12sec
Always off
OFF
Always lighting
ON
7 levels
-3~+3
- 52 -