Adjusting The Bracelet - Chase-durer Abyss 1000 Professional Operation Manual

NOTE* Use flat blade screwdrivers
that fit the screws.
Place a small drop of LOCTITE
222 or clear nail polish on the
screw thread to prevent it from
loosening and getting lost.
Adjust the bracelet by removing links in a simple procedure involving just two small screwdrivers.
Carefully insert the blades of the screwdrivers in opposing screw slots and turn counterclockwise
to loosen and remove retaining screw
Pull connecting shaft
that needs to be removed.
Reassemble by reinserting connecting shaft to close the bracelet and secure with screw .
Take care not to over tighten the screws or mar the bracelet's fine finish.
NOTE* When removing more than one link, alternate from either side of the buckle
so the buckle and watch case remain relatively centered on the bracelet.

Adjusting the Bracelet

A
®
A
from connecting shaft .
B
straight out to open the bracelet and repeat the procedure for each link
If the screwdrivers are too small or too
large, they may damage the screws and
will be more likely to slip and damage
the bracelet's finish.
B
B
B
4.
A