Installation - ADJ MIRAGE Q6 PAK User Manual

INSTALLATION

IP RATING
The Mirage Q IP is IP65 rated. It is completely dust tight, and is protected against low-pressure
directed jets of water from any direction. The charging devices and flight case are not IP-rated,
and are intended for use in dry, indoor conditions only.
FLAMMABLE MATERIAL WARNING!
Keep device a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The unit MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Before installing or mounting any device, a professional equipment installer MUST be consulted to
determine whether the mounting structure or surface is properly certified to safely support the com-
bined weight of the fixture, clamps, cables, and accessories.
Overhead fixture installations must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable that meets all local, national, and country codes and regulations.
Operating temperature range is 32 to 113 degrees F (0 to 45 degrees C). Do not operate the device
if ambient temperatures fall outside of this range.
This fixture should be installed in areas outside walking paths, seating areas, and areas where unau-
thorized personnel might be able to reach the device by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing.
Allow approximately 15 minutes for the fixture to cool down before servicing.
ADJ Products, LLC - www.adj.com - Mirage Q6 Pak User Manual Page 11