Other Faults - Kaco blueplanet hybrid 10.0 TL3 Operating Instructions Manual

I141 Communication of hy-switch
I142 Battery communication
I903 Commissioning
I904 FRT undervoltage
I905 FRT overvoltage
I906 Power reduction
Overfrequency
I907 Power reduction
Underfrequency
I908 Unsaved settings
I909 AC overvoltage
I911 hy-switch connection
9.4

Other faults

Fault pattern:
Display without function and device cannot be switched on
Possible solutions:
– The device runs without battery power and is shut down at night.
It starts automatically the next day.
– The device runs without battery power and the power supply from the PV modules is interrupted. Check the
position of the DC disconnector and the fuse protection of the supply line. Contact your installer.
– The device has a power supply fault. Check the power supply and functioning of the battery. Contact your in-
staller.
blueplanet hybrid 10.0 TL3
hy-switch is switched to active, but cannot be addressed.
Check the system components of hy-switch
The battery is switched to active, but cannot be ad-
dressed. Check the battery
Device has not yet been commissioned or sufficiently
configured. Perform the commissioning procedure.
FRT undervoltage detected Wait until the result is no
longer present. If it persists, check the installation.
FRT overvoltage detected Wait until the result is no
longer present. If it persists, check the installation.
Power reference due to overfrequency. Wait until the re-
sult is no longer present.
Power reference due to underfrequency. Wait until the
result is no longer present.
New settings have been made on the device, but have
not yet been saved. If necessary, the settings can be
saved under User Settings.
AC overvoltage detected. Wait until the result is no
longer present. If it persists, check the installation.
Unstable connection to hy-switch. Check the installation.
Page 53