Steps
1. Remove the four (M2x3) screws that secure the display panel to the display assembly.
2. Lift to turn over the display panel to access the display cable.
3. Peel the conductive tape covering the display cable connector.
4. Peel the clear tape covering the display cable connector.
5. Peel the rubber spacer covering the display cable.
6. Lift the latch and disconnect the display cable from the connector on the display panel.
Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display panel and provides a visual representation of the installation procedure.
48
Removing and installing components