Preliminary Note; Intended Use; Scope Of Delivery; Technical Specifications - Auriol 4-LD4246 Usage And Safety Instructions

RADIO-CONTROLLED WALL CLOCK

Preliminary note

Please read the instruction manual before using the product for the first time- even if you
are experienced at using electronic equipment. Please take special care when reading
the chapter "Important safety information". Keep this instruction manual so you may use
it a reference material in the future. If you sell or give this product to someone else it is
very important to also include this manual.

Intended use

This electronic appliance is intended for time display and the described additional
features. Any other use or modification of the electronic appliance does not comply
with the intended uses. The manufacturer is not liable for damages caused by improper
use or misuse. The device is not intended for commercial use.

Scope of delivery

wall clock
•
1 x 1,5 V AA R6/LR6 battery
•
instruction manual
•

Technical specifications

Quartz movement
•
Radio signal DCF77
•
Thermometer -20 to +50 °C
•
Hygrometer 10 to 98 %
•
Battery powered 1,5 V AA R6/LR6
•

Important safety information

Set up the device safely

Hang the wall clock on a flat wall using a nail or screw. The wall clock is not designed
for operation in rooms with high humidity (i.e. bathroom). Make sure that:
• no direct heat sources (i.e. radiators) influence the device;
• no direct sunlight reaches the device;
• contact with splashing or dripping water must be avoided
• the device doesn't stand near magnetic fields (i.e. speakers);
• no foreign objects penetrate the housing.
- 23 -
• candles and other open flames must be kept away from this product at all times to
prevent the spread of fire

User

This device may be used by persons (including children over 8 years of age) with
reduced physical, sensory or mental abilities or lack of experience and knowledge, if
they are supervised or instructed regarding the safe use of the device and understand
the dangers that may arise. Children may not play with the device. Cleaning and user
maintenance of the device may not be performed by children without supervision. Keep
packaging films out of the hands of children. There is a danger of suffocation.

Batteries

Keep batteries out of reach of small children. If a battery is swallowed, you must seek
medical attention immediately. Batteries/rechargeable batteries must always be
inserted in the correct polarity. If necessary, clean the battery and device contacts.
Never attempt to recharge non-rechargeable batteries. Never short-circuit or attempt
to open batteries. Never throw batteries into fire as they may explode. If the device will
not be used for an extended time period, remove the battery and store the device in a
dry and dust-free area. Improper use of the battery can lead to explosion or leakage.
If the battery leaks, avoid contact with skin, eyes and mucous membranes. Use gloves.
If you are exposed to battery acid, rinse the affected areas with plenty of clean water
and immediately seek medical attention. Remove discharged batteries from the device
as they present an increased risk of leakage.

Setup

Insert a 1,5 V AA R6/LR6 battery in the correct polarity into the battery compartment
on the back of the wall clock. The hands will move to the 12:00:00, 4:00:00 or
8:00:00 o'clock position and stop. The clock will now begin to receive the DCF77
radio signal. The reception process can take 3-10 minutes. After successful reception of
the radio signal, the hands will automatically move to the correct time. If the reception
process fails, it will be repeated hourly. The reception process can be restarted
manually by pressing and holding REC on the back side of the clock for 5 seconds. The
hands will move to the 12:00:00, 4:00:00 or 8:00:00 o'clock position and stop. The
clock will now begin to receive the DCF77 radio signal.

Manual time setting

This feature cannot be used while the clock is attempting to receive the radio signal
(Hands at 12:00:00, 4:00:00 or 8:00:00). Press and hold the SET button on the
backside of the clock for 5 seconds. The clock will enter manual mode. Press and hold
SET to move the hands to the correct position.
- 24 -