Table of Contents
Advertisement
Tip
Prior to ironing, check whether there is sufficient water in the tank and add more prior
to ironing, if necessary. This way, you will not need to interrupt ironing to refill with
water. This is safer and saves time.
1.
Remove the mains plug from the socket and allow the iron to cool off completely.
2.
Slide the steam controller all the way to the right to the position marked 0.
3.
Flip open the cover of the filling opening.
4.
Fill the filling cup with water up to the 200 ml mark.
5.
Hold the iron on a slight angle and allow the water to run carefully into the filling
opening of the tank.
6.
After filling, check that the MAX marking on the tank has not been exceeded.
For this, place the iron on its stand base. Pour away any excess water.
Maximum filling capacity of the tank: 320 ml.
7.
Flip the cover back.
Set temperature
CAUTION
Please note the information and symbols in the textiles to be ironed. The symbols
on the temperature control knob correspond to the standard commercial care
symbols.
The temperature is set using the temperature control knob. The points
knob have the following meaning:
Note
The steam shot function is only available in the top temperature range.
HELPLINE No. U K / N.IRELAND 0800 328 60 20 REP. IRELAND 00 800 44 67 58 88
WEB SUPPORT info@globaltronicssupport.com
Model Number: GT-SI-01-UK
Top temperature range
Cotton, linen etc.
Medium temperature range
Wool and synthetic fibres, e.g.
, polyester, lilion, etc.
viscose
Low temperature range
Chemical fibres, e.g. dralon, perlon,
nylon etc.
on the control
9
Advertisement
Table of Contents
