Cleaning - Delta essentials GT-SI-01-UK Instruction Manual

Information on the anti-limescale system
In order to extend the life of the iron, an anti-limescale cartridge is installed. It reduces the
limescale formation/deposits from escaping steam. This is cleaned using a self-cleaning
system. However, the formation of limescale will not be entirely prevented by the anti-
limescale cartridge.
Information on the anti-drip function
This function prevents water dripping out of the sole plate, if the temperature is too low
for generating steam. You can identify the anti-drip function by the clicking sound,
particularly when heating up or cooling down. This is normal and shows that the iron is
fully functional.

Cleaning

HAZARD
- Disconnect the mains plug from the socket.
- Allow the iron to cool off completely.
Using the self-cleaning function
The iron has a self-cleaning function With this, dust and small particles of dirt are removed
from the tank.
With average use, you should clean the iron using this function once a month:
1. Fill the tank no more than half way, see page 8
2. Turn the temperature control knob to MAX. Wait until the orange control lamp goes
out.
7. Place the iron on its stand base or the appropriate stand surface on your ironing board.
8. As soon as the iron has heated up again - orange control lamp is off - iron an old, but
clean towel, or similar, in order to remove the last dirt particles from the soleplate.
HELPLINE No. U K / N.IRELAND 0800 328 60 20 REP. IRELAND 00 800 44 67 58 88
WEB SUPPORT info@globaltronicssupport.com
14 Model Number: GT-SI-01-UK
3. Hold the iron over a sink or large cloth.
4. Press the SELF-CLEAN button. Water and steam is
discharged from the outlets of the soleplate.
5. Shake the iron back and forth to remove particles of dirt
in the tank.
6. Release the self-clean button as soon as no more water
is being discharged.
.