Chamberlain Security+ 974-315CB Owner's Instructions

The Plug-In Light Control is designed to operate
lights according to the rating chart shown. Please
read the instructions and power limitations carefully to
ensure proper use and maximum safety. NOT
recommended for use with toasters, coffee pots, or
halogen lighting systems.
This Light Control can be operated by Model 900
Series portable remote controls and Keyless Entries.
The Plug-In Light Control receiver needs to learn
the remote control code. Follow the instructions
below:
• Select a remote control push
button to operate the light control.
• Pry up the lower edge of the
actuator with a coin or screwdriver
as shown.
• Plug the light control into a 120 Vac polarized
outlet. The plug contacts are designed for
polarized outlets only. The power indicator light will
turn on if there is power to the outlet.
• Press and hold the remote control push button you
chose to activate the light control.
• Then press and release the "Smart" (learn) button
on the receiver with a pen or pencil tip. The
adjacent yellow indicator light will FLASH once.
• Release the remote control push button. Code
setting is now complete. Snap actuator back on
light control.
The remote control push button must be held down
until the receiver indicator light flashes for the light
control to learn the remote control's code.
If the receiver SMART button is pressed and held
until the yellow indicator light alongside goes out
(in about 6 seconds), all memorized codes will
be erased.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or
modifications of this receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
114A2622B
Model 974-315CB Security✚
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fire, the light control is ONLY for indoor
use.
Select a
push button
If two or more light products are installed, the
receivers must be located at least 10 feet apart to
prevent electronic interference.
• First, plug the lamp into a wall outlet and turn it ON.
• With the lamp still in the ON position, plug it into
polarized outlet on the light control. The bulb will
not light.
• TO TEST: Press and release the light control
actuator. The light should turn ON. Press the
remote control push button. The light should turn
OFF.
If the remote control does not activate the light, check
to be sure:
• You are pressing the remote control push button
selected to operate the light control.
• The remote control battery has power. Refer to the
remote control instructions for battery changing
information.
Resistive Load ......................................1200 Watts
Motor Load ...................................................1/3 HP
Incandescent Lamp.................................600 Watts
© 2006, The Chamberlain Group, Inc.
All Rights Reserved
Plug-In Light Control
OWNER'S INSTRUCTIONS
WARNING
CAUTION
Actuator
Power Indicator
Light
Smart Smart
Indicator (Learn)
Light Button
OPERATING INSTRUCTIONS
RATING
®
120VAC
Polarized
Wall Outlet