Operation - Campingaz ADELAIDE PLANCHA TTL Operation And Maintenance

GB
Venturi tube
openings
i) LIGHTING THE BURNERS MANUALLY
If automatic ignition does not work, turn the control knob
to "OFF" ( ).
Remove the cooking plate. Hold a lighted match next to
the burner, then push in the control knob and turn it to the
"HI" position (
with protective gloves, being sure to correctly position the
drippings evacuation hole (see view 2, page 6).
j) EXTINGUISHING THE BURNERS
Return the control knobs to the "off" position ( ), then close
the cylinder valve.
k) REPLACING THE GAS CYLINDER
- Always work in a well ventilated area and never in the
presence of a flame, spark or heat source.
- Return the control knobs in the "off" position ( ) then
close the cylinder valve.
- Remove the regulator, check that the sealing joint is in
good condition.
- Put the full cylinder in place, refit the regulator, taking
care not to apply stress to the hose. Check for gas
leaks.
l) OPERATION
When used for the first time, heat up the barbecue
(depending on model: remove the lid) with its burners in
full on position (
order to eliminate any odors resulting from the paint on
the new parts.
We recommend using protective gloves for handling
elements that are particularly hot. Use long-handled
utensils to manipulate food on the cooking plate.
Before cooking, preheat the device for a few minutes in
the "HI" position (
Cooking speed can be regulated via the adjustment
buttons: between the full flow position (
flow position ( ).
Important:
If one or several burners go out whilst you are using the
barbecue, move the adjustment buttons to OFF
immediately ( ) . Wait five minutes to allow the unburned
gas to escape. Only carry out the lighting steps after this
time.
burner holes
). Put the cooking plate back in place
) , for approximately 15 minutes in
).
) and medium
The device has four adjustable feet.
Regulate the slant of your Plancha by
turning the feet to the right or to the left.
m) CLEANING AND MAINTENANCE
- Never modify the barbecue: any modification may prove
dangerous.
- In order to maintain your barbecue in perfect operating
condition, it is recommended to clean it periodically
(after 4 or 5 uses).
- Wait until the barbecue has cooled down before
cleaning.
- Close the gas cylinder.
- The grill burner must be cleaned and checked every 3
months. Remove the entire burner and check that no
dirt or spider webs block the venturi tube openings,
which may cause the burner to be less efficient or cause
a dangerous gas fire outside the burner.
- Clean the top of the burner, as well as the sides and
base, using a moist sponge (water with washing up
liquid). If necessary, use a damp steel brush.
- Check that all burner outlets are clear and let dry before
using again. If necessary, use a wire brush to unclog
the burner outlets.
- Refit the grill burner correctly.
- Clean the orifices on the Venturi jet (see diagram below)
or the burner if necessary.
N.B.: Frequent cleaning of the burner maintains it in good
condition for many uses and prevents premature
oxidation, notably due to acid residue from cooking.
Oxidation of the grill burner is, however, normal.
Base walls, control panel, grease recipient
Clean these elements from time to time using a sponge
with washing up liquid. Do not use abrasive products.
Cooking surface
The cooking surface is covered with enamel. To clean it,
we recommend first removing all cooking residues with a
sponge or scouring pad. Next, remove grease with a
dishwashing detergent or by putting the cooking grill in
your dishwasher.
Be careful to avoid hitting the cooking surface against a
hard surface since this could chip the enamel.
n) STORAGE
- Close the gas cylinder valve after use.
- If you store your barbecue indoors, disconnect the gas
cylinder and store the cylinder outdoors.
- If you store your barbecue outdoors, it is recommended
that a protective cover be used.
- When not used for a long period of time, it is
recommended that the barbecue be stored in a dry,
sheltered place (eg: garage).
o) ACCESSORIES
ADG advises that its gas barbecues should
systematically be used with accessories and
replacement parts from Campingaz. ADG accepts no
responsibility for any damage or malfunction due to
the use of accessories and/or replacement parts from
other brands.
14