General Safety Recommendations - Nabco Magnum 4A Control Wiring And Adjustment Manual

Magnum 4A Control Wiring and Adjustment Manual
Part #15-10682
WARNING
Notice:
DANGER
Notice:
CAUTION
DANGER
CAUTION
CAUTION
CAUTION
Note:
Note:
Note:
Note:
iv

GENERAL SAFETY RECOMMENDATIONS

Read, study and understand general safety recommendations, warning labels,
installation and operating instructions contained in, or referenced in this manual
before operating. If you do not understand the instruction, ask a qualified
technician. Failure to do so may result in bodily injury, or property damage and
will nullify all warranties.
This manual and the owner's manual must be given to and retained by the
purchasing facility or end user.
Disconnect all power to the junction box prior to making any electrical
connections. Failure to do so may result in seriouc personal or fatal injury. When
uncertain whether power supply is disconnected, always verify using a voltmeter.
Wiring must meet all local, state, federal or other governing agency codes.
All electrical troublshooting or service must be performed by trained, qualified
electrical technicians and comply with all applicable governing agency codes.
Do not place finger or uninsulated tools inside the electrical controller. Touching
wires or other parts inside the enclosure may cause electrical shock, serious
injury or death.
The Ground wire from the Magnum IV Control 120 VAC Harness, and the Incoming
120 VAC Ground wire must be connected to the Ground screw located within the
Swing door Header.
Do Not touch other parts of the Magnum IV Control board with a screwdriver or
anything else metal. Damage to electrical circuitry may occur.
If the door appears broken or does not seem to work correctly, it should be
immediately removed from service until repairs can be carried out or a qualified
service technician is contacted for corrective action.
All Adjustments must be made with a small screwdriver. Do Not use a pencil.
Final installation must conform to current versions of ANSI 156.19 for Low Energy
Swingers or ANSI 156.10 for Full Automatic Swingers.
Study and understand both ANSI Standard Codes A156.10 and A156.19.
Do Not take shortcuts.
www.NabcoEntrances.com
Rev. 7-03-14