Table of Contents
Advertisement
www.NabcoEntrances.com
Rev. 7-03-14
CHAPTER 1: Scope
Section 1a. To the Installer
The purpose of this manual is to familiarize the installer and purchaser with the proper
installation and operation of this system. It is essential that this equipment be properly installed
and operational before the door is used by the public. It is the installer's responsibility to inspect
the operation of the entrance system to be sure it complies with any applicable standards. In
the United States, ANSI Standard 156.10 is used to cover Full Automatic swing doors and ANSI
Standard 156.19 is used to cover Low Energy swing doors. Other local standards or codes may
apply. Use them in addition to the ANSI standards.
Instruct the building owners and operator on the essentials of the operation of the Magnum 4A
Control and Operator. The owner should follow these instructions to determine whether the door
is operating properly and should immediately call for service if there is any malfunction.
All installation changes and adjustments must be made by qualified, NABCO trained technicians.
Section 1b. Objective
The Magnum 4A Control is designed to be installed within the Header of Gyro Tech Swing doors.
Earlier versions of Gyro Tech GT-300, GT-400, GT-500 and GT-700 Swing Door Operators can be
retrofitted with the new Magnum 4A Control Board. For more information on Retrofit Kits, please
contact Customer Service at 1-888-679-3319.
This manual offers step by step instructions.
Scope
Magnum 4A Control Wiring and Adjustment Manual
Part #15-10682
1-5
Advertisement
Table of Contents
