Nabco Magnum 4A Control Wiring And Adjustment Manual page 21

Swing door operator
Table of Contents

Advertisement

www.NabcoEntrances.com
Rev. 7-03-14
USE THESE CONNECTIONS ON INSWING
DOORS WITH PANIC BREAKOUT
Black
Brown
Breakout Limit Switch: N.O.
(Black and Brown)
11.►Go to ends of each (Red) wire connected to Panic Latch Harness. Cut white plastic connectors
12.►Strip all wire ends 1/4 inch.
DN 0565
13.►Go to the 6 Pole Terminal Block.
14.►Insert Red wires into into Pole 3 (Continuous Safety) and into Pole 5 (Common). Please see
The new "Fail Safe" safety circuit feature on the Magnum control is only available on recent
 6.a.b: Using the Panic Breakout Latch/Switch on a Closed Loop Continuous Safety Circuit
controls as identified by the last (3) digits reading (13X or Higher) on a Label that is adhered to a
Microprocessor IC located on the Magnum 4A Control board.
Magnum Control boards that display UL Labels with the last (3) digits reading (12X or Lower) do
not have the Fail Safe feature. When this feature is activated and the door is broken out, the Panic
Breakout Switch OPENS the circuit to activate the Safety w/Lockout feature.
The following section explains how to connect the Panic Latch Switch to prevent activation when
Wiring Safety Devices
Panic Latch must be flipped.
Arrow marked "EXT" must
point to the Interior of
building. ( Contacts must close
when door is broken out)
Part # 21-9934
300/400/500 Harness
for Magnum Board
When the unit has Panic Breakout feature,
Breakout Limit Switch Signal and Panic Latch Signal
MUST be connected to Continuous Safety input,
Terminals 3 and 5
Operator Assembly
Back Check Limit Switch
Red: Comm, Blue: N.C.
off. Please see Figure 6-4.
Figure 6-3.
Magnum 4A Control Wiring & Adjustment Manual
Red
Red
Panic Latch Kit
Part # 11- 0941
Figure 6-3 Wire Panic Latch for Full Automatic doors
EXT
Figure 6-4 Cut off Panic Latch Harness Connectors
MEC
8512A13X
6
5
4
3
2
1
Part # 22-10065
Harness Assy
for Single
STOP
BCHK
TDPG
CLOSE
F1
OPEN
TDAS
LCHK
AUX
Fuse 1: 0.5 A 24 VAC
PWR
LED
SIGNAL
INPU T
J2
TRANSFORMER
J1
R28
AC IN
J4
CURRENT
SW2
LIMIT
SW1
MO V
MOTO
R
Capacitor
J5
F2
REL AY
REL AY
Fuse 2: 5 A 120/240
MAGNUM 4A
Part #15-10682
Part # 12-13166
Motor Fuse
(GT300, 400, 500)
DN 0566D
6-19

Advertisement

Table of Contents
loading

Table of Contents