Nabco Magnum 4A Control Wiring And Adjustment Manual page 16

Magnum 4A Control Wiring & Adjustment Manual
Part #15-10682
Open
Potentiometer
BCHK
(Back Check)
TDAS
(Time Delay Activating Signal)
TDPG
(Time Delay Push-N-Go)
4-14
Sets opening speed of door.
Door opened at wrong speed.
Event
Sets Back Check speed.
Back check speed requires adjustment.
Event
Determines how long door will stay open after activation (or input signal) is released.
Used when door is in Timer Mode (Dip Switch #4).
Note: The time delay does not begin counting until after loss of activation and door has
Full Automatic door
reached Back Check.
1 - 60 seconds
Low Energy door
Hold Open time requires adjustment.
Event
Determines how long door stays open after Push-N-Go is activated (Dip Switch #4).
Full Automatic door
1 - 60 seconds
Low Energy door
Hold Open time requires adjustment after
Event
door is pushed.
GT300/400/500 units come standard with a clutch gear in the operator. On
operators that use a clutch gear, Push n Go is only active from the fully closed position
X
once the door is manually pushed out of latch position.
If Push n Go is desired for all door positions, a clutchless operator must be ordered.
The GT-710 uses a Direct Drive and that is equavelent to a clutchless operator.
X
Description
Recommended start position 12
o'clock.
X
Clockwise
• Door will open faster.
X
Counterclockwise
• Door will open slower.
X
Recommended start position 11
o'clock.
X
Clockwise
• Increases Back Check speed.
X
Counterclockwise
• Decreases Back Check speed.
X
Recommended start position 12
o'clock.
X
Dip Switch #4 must be ON
Clockwise
X
• Increases time door will stay open.
X
Counterclockwise
• Decreases time door will stay open.
X
Recommended start position 12
Action
(Full Automatic doors)
o'clock.
X
Clockwise
• Increases time door will stay open.
X
Counterclockwise
• Decreases time door will stay open.
X
www.NabcoEntrances.com
Rev. 7-03-14
Action
Action
Action
Adjustments and Status LEDs