Maintenance - Kaiser KG Series Manual

Fig. 4a - Abb. 4a -
16
. 4a
MAINTENANCE GAS/ELECTRICAL
Prior to any operation, disconnect the applia
from the electrical system. For long-life to the
equipment, a general cleaning operation must
take place periodically, bearing in mind
following:
the glass, steel and / or enamelled parts
must be cleaned with suitable non-
abrasive or corrosive products (found on
the market). Avoid chlorine-base products
(bleach, etc.);
avoid leaving acid or alkaline substances
on the working area (vinegar, salt, lemon
juice, etc.).
the wall baffle and the s
(mobile parts of the burner) must
washed frequently with boiling water a
detergent, taking care to re
possible encrustation. Dry carefully and
check that none of the burn
or partially clogged;
the electrical parts are cleaned with a
damp cloth and are lightly
lubricating oil when still warm.
the stainless steel grids of the working
area, after having been heated, take on a
bluish tint which does not deteriorate the
quality. To bring colour b
state, use a slightly a
N.B.- Cleaning o f the taps
qualified personnel, who must be consulted in
case of any functioning anomaly.
Check periodically the state of conservation
flexible gas feed pipe. In case of leakag
immediately the qualified technicians for its
replace ment.
Maintenance vitroceramic surface
(Fig. 4a) First of all remove stray food bits and
grease drops from the cooking surface with the
special scraper. Then clean the hot area as best
as possible with SIDOL, STAHLFIX or ot
similar products with a papertowel, then rinse
again with water and dry with a clean cloth. Piece
of aluminum foil and p
inadvertently melted or sugar remains or highly
sacchariferous food
immediately from the hot cooking area with th
speci al scraper.-This is to avoid any possible
damage to the surface of the top. Under no
circumstan ces should
irritating chemical detergents be used such
oven sprays or spot removers.
GB
mall covers
move every
er holes is fully
greased with
ack to its original
brasive product.
must be carried out by
of
e, call
lastic material which have
have to be removed
abrasive sponges
nce
the
be
nd
the
her
s
e
or
as