Instructions For Use; Installation; Use - Kaiser KG Series Manual

GB

INSTRUCTIONS FOR USE

INSTALLATION

All the operations concerned with the installation
(electrical connection) must be carried out by
qualified technicians, in terms with the standards in
force. For specific instructions, kindly read the part
reserved for the installation technician.

USE

Gas burners (Fig. 1-3-3a-3b). The ignition of the
gas burner is carried out by putting a small flame
to the upper part holes of the burner, pressing and
rotating the corresponding knob in an anti-
clockwise manner, until the maximum position has
coincided with the marker. When the gas burner
has been turned on, adjust the flame according to
need. The minimum position is found at the end of
the anti-clockwise rotation direction. In models with
automatic ignition, operate the knob as described
above, pressing simultaneously, the corresponding
push-button. For models with
automatic/simultaneous (with one hand) ignition, it
is sufficient to proceed as described above using
the corresponding knob. The electric spark
between the ignition plug and the burner provides
the ignition of the burner itself. After ignition,
immediately release the push-button and adjust
the flame according to need.
For models with a thermoelectric safety system,
the burner is ignited as in the various cases
described above, keeping the knob fully pressed
on the maximum position for approximately 3/5
seconds. After releasing the knob, make sure the
burner is actually lit.
N.B. - we recommend the use of pots and pans
with a diameter matching that of the burner, thus
preventing the flame from escaping from the
bottom part and surrounding the pot
- do not leave any empty pots or pans on the fire
- do not use any tools for grill-cooking on Crystal
hobs.
When cooking is finished, it is also a good norm to
close the main gas pipe tap and/or cylinder.
6