AEG DVD 4532 USB Instruction Manual & Guarantee page 55

Dolby settings
Video Setup Page
05-DVD 4532 USB-CR_GB.indd 55 05-DVD 4532 USB-CR_GB.indd 55
Dual/Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the
„left" stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the
„right" stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the
„both" stereo channel is transmitted to all speakers.
Dynamic
The term „Dynamic" (Dynamic Range) describes the ratio of quietest and
loudest sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching a
DVD in a relatively loud environment. You can now increase the volume to
be able to hear also the very quiet passages, however with the disadvan-
tage that loud passages will be unacceptably loud. In this case it would
make sense to compress the dynamic range (i.e. reduce) and increase the
output volume at the same time.
FULL -1/8: The dynamic range is compressed slightly (1/8) to full
(FULL).
OFF: The dynamic range is not compressed at all (default).
Components (video output)
Select the video output option for the playback device that is connected
and which you wish to use. Choosing the right signal format depends on
the type of connection and the playback device (see also the operating
manual of the replay unit).
CVBS: Select this option if your playback device is connected to the
DVD player via the composite video and/or S-video connection.
YUV: Select this option if your playback device is connected to the
DVD player via the component video connection.
RGB: Select this option if your playback device is connected to the
DVD player via the SCART connection.
NOTE:
If you would like to select the „RGB" setting, please ensure that
your playback device supports this setting.
By pressing the VIDEO MODE button (Fig. 3/33) you can also
switch between the video output options. Whereby "YPbPr"
corresponds to the "Progressive" setting (see "Scan mode").
English
55
21.02.2008 11:15:59 Uhr 21.02.2008 11:15:59 Uhr