AEG DVD 4532 USB Instruction Manual & Guarantee page 42

English
42
Connecting the Video cable
Fig. 2/15
Fig. 2/13
Fig. 2/16
Fig. 2/17
05-DVD 4532 USB-CR_GB.indd 42 05-DVD 4532 USB-CR_GB.indd 42
The video cable transmits the video data from your DVD-Player to the TV
or the Video-Projector.
There are four diff erent ways of connecting the DVD-Player with your TV/
Video-Projector. Select one of these possibilities to suit your replay unit.
NOTE:
If you do not use a SCART connection it is necessary to make an
additional audio connection for the transmission of the audio data (i.e.
the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
Component Video
Connection using a Component Video cable ensures a very high replay
quality.
Component Video transmits only Video signals.
1. Plug each of the three jacks into the corresponding sockets on the
DVD-Player.
2. Plug the jacks into the corresponding socket on your playback device.
In the "Video" menu select the "Component" submenu. Here you can
change the settings „CVBS", „YUV" and „RGB" on the playback device
that you have connected. Please see the operating instructions of the
connected device for the correct setting.
S-Video
Connection using a S-Video cable ensures a very high replay quality.
Component Video transmits only Video signals.
1. Plug the S-Video jack into the socket on the back of the player.
2. Plug the S-Video jack into the corresponding socket on your playback
device.
Composite-Video
Composite-Video is used to transmit both Video data.
1. Plug the Composite-Video jack into the socket on the back of the
player.
2. Plug the Composite-Video jack into the corresponding socket on your
playback device.
21.02.2008 11:15:51 Uhr 21.02.2008 11:15:51 Uhr