Vitek VT-1476 CM Manual Instruction page 5

• In order not to damage the blades, do not
process very hard products, such as ice,
frozen products, grits, rice, seasonings
and coffee.
Using the whisk attachment
Use the whisk attachment only for making
cream, biscuit dough or mixing ready des-
serts.
NOTE: Before assembling, make sure that
the power plug is not inserted into the
socket.
• Insert the whisks (7) into the gear head
(6).
• Insert the gear head (6) into the motor
unit (1) and turn it clockwise until clamp-
ing.
• Insert the plug into the socket.
• Put the whisk attachment into the bowl
with products or use the bowl for mixing
products (8), use the control (4) to set
the required speed 1-7, press and hold
the (2) button during the operation. When
Turbo (3) button is pressed, the whisks
will rotate at maximal speed.
USING THE BLADES
The blade is used to chop meat, cheese,
onion, aromatic herbs, garlic, carrot, wal-
nuts, almond, and fruits.
Attention! Do not chop very hard prod-
ucts, such as nutmegs, coffee beans
and cereals.
Before you start to chop:
• Cut meat, cheese, onion, garlic, carrots
into (approximately equal) slices.
• Remove stems from herbs, peel the
nuts.
• Remove bones, tendons and cartilage
from meat.
• Remove the "protecting housing" from
the blades (18).
Chopping
NOTE: Do not overfill the processor bowl.
1476.indd 5 1476.indd 5
Be careful: The blades are very sharp!
Always hold the blade by the plastic tip.
1. Put the drive shaft (17) on the proces-
sor bowl axis (16).
2. Put the blade (18) on the splines of the
drive shaft (17).
3. Put the products into the processor
bowl (16).
4. Put the lid (13) on the bowl (16).
5. Put the gear lid (9) and lock it on the
bowl (16).
6. Put the motor unit (1) on the gear lid (9)
and turn it clockwise until clamping.
7. Use the control (4) to set the required
speed 1-7. To switch on the unit, press
and hold the (2) button. When pressing
Turbo (3) button, the blade will rotate at
maximal speed. During operation hold
the motor unit (1) with one hand, and
the bowl (16) with the other hand.
8. After usage of the unit, take the plug
out of the socket, press the (10) button
and, holding it, disconnect the motor
unit (1) from the lid (9), rotating it coun-
terclockwise.
9. Then remove the gear lid (9) from the
bowl (16), by pressing the (11) buttons.
Note: it is impossible to remove the
lid (9) from the bowl, if the motor
unit (1) is not disconnected.
10. Carefully remove the blade (18).
11. Remove the chopped products from
the processor bowl (16).
12. Clean, wash and dry all the used details
immediately after operation.
13. Put the protective housing on the blade
(18).
Attention! Time of continuous opera-
tion should not exceed 30 sec.
Using the discs with graters/shredders
1. Put the drive shaft (17) on the proces-
sor bowl axis (16)
5
ENGLISH
25.01.2011 12:48:38 25.01.2011 12:48:38