Table of Contents
Advertisement
the front panel and remote permanently assigned.
HEX codes for use with universal remote controls
are available from Bryston upon request.
BP-18 / BDA-3.14
Code
BR-20 IR Remote
Trigger Control
The BR-20 can control the power state of other
attached devices as well has have its power state
controlled. Two DC trigger outputs and one trigger
input are provided. Each is a tip/sleeve (mono mini
plug) and is wired with the tip at V
ground.
Triggers will commonly be used to trigger the
attached equipment on or into standby. When the
BR-20 is powered on, voltage is present at the tip
of this connector and is removed when the unit is
placed into standby.
Front Panel
1. Power / Standby
Press this button to toggle the BR-20 on or into
standby mode.
6
and sleeve
DC
Unlit BR-20 is not receiving power. Plug unit into
AC mains power.
Red Plugged into AC Mains but in standby
mode.
Green or
BR-20 is on and operational.
Blue
Yellow Receiving valid IR or RS232 data
Blinking
Fault indicated. Contact customer service
Red/Green
2. Volume Control
Rotate this knob clockwise to increase the
output volume or counterclockwise to decrease
the volume. As volume increases, successive
LEDs around the knob will light indicating
relative loudness. Pressing the knob in will
activate the setup menu and act as an 'Enter'
button within the menu.
3. Mute
Pressing this button or the Mute button on the
remote or muting the unit through the web
user interface will disconnect the main outputs.
When the unit is muted, the LED will illuminate
red. Mute does not affect the headphone or
record outputs. When navigating the setup
menu, press mute to go back a level without
saving changes.
4. Analog Input Selectors
The BR-20 features 4 analog inputs into which
you can connect analog source components.
Press the input button corresponding to the
rear panel input of your choice to listen to that
source component.
5. Digital Input Selectors
The BR-20 features 7 digital inputs into which
you can connect digital source components
plus a built in digital player source component.
Optionally, the BR-20 can be fitted with an
HDMI interface which adds 4 more inputs for a
total of 12 possible digital source components.
Each of these buttons can be programmed
to correspond with the digital input of your
Advertisement
Table of Contents
