Trigger Control - Bryston BP-17 cubed series Owner's Manual

IR Control
You may control the BP-17³ with a traditional
infrared remote control such as Bryston's BR2.
To use a Bryston BR2 with the BP-17³, press the
PREAMP button. Volume and Mute remain active
even when the remote is in D/A or CD mode.
CODE POWER
UP-SAMPLE OPTO-1 OPTO-2
1 2 3
SPDIF-1 SPDIF-2 SPDIF-3 VOLUME
4 5 6
A/D Aux/Ph CD
SPDIF-4 AES/EBU USB MUTE
7 8 9
Tuner TV Video
D/A CD PREAMP
0
TIME SCAN RANDOM REPEAT
D1 D2 D3 D4
PREVIOUS NEXT FORWARD
BACK
Rec Phase
EJECT STOP PAUSE PLAY
BR2
To configure the BR-2 for control over the BP-17³,
execute the following steps:
1. Press and hold the CODE button on the BR2
remote until the red LED begins to flash (usually
takes about 5 seconds).
2. As soon as the LED remains steadily RED, release
6
the CODE button and enter the the 3 digit code
712 before the LED goes out. The LED will flash
twice after a valid code has been successfully
entered.
Inputs 1-4, Balanced Input 1 and Balanced Input
2 can be selected by pressing the buttons that
correspond with 1-6 where 5 and 6 select Balanced
Input 1 and Balanced Input 2 respectively. Digital
inputs D1-D4, Record Monitor, Balance L/R are
marked in blue.
CODE POWER
Special codes such as those used for bypass or
trigger assignment can be sent by pressing the
UP-SAMPLE OPTO-1 OPTO-2
CODE button once, then entering the 3 digit code.
1 2 3
HEX codes for use with universal remote controls
SPDIF-1 SPDIF-2 SPDIF-3 VOLUME
are available from Bryston upon request.
4 5 6
A/D Aux/Ph CD

Trigger Control

SPDIF-4 AES/EBU USB MUTE
The BP-17³ can control the power state of other
7 8 9
attached devices. Two DC trigger outputs are
Tuner TV Video
D/A CD PREAMP
provided. Each is a tip/sleeve (mono mini plug) and
is wired with the tip at V
0
TIME SCAN RANDOM REPEAT
Trigger 1 will commonly be used to trigger the
attached amplifier(s) on or into standby as it is not
D1 D2 D3 D4
source dependent. When the BP-17³ is powered on,
PREVIOUS NEXT FORWARD
BACK
voltage is present at the tip of this connector and is
removed when the unit is placed into standby.
Rec Phase
Trigger 2 can be configured to activate based on
a selected source. Voltage is present at the tip of
EJECT STOP PAUSE PLAY
this connector when a specific source is selected.
For instance, if a BCD-3 CD player is connected to
Balanced Input 1, you may wish to configure Trigger
BR2
2 to activate on when Balanced Input 1 is selected.
To assign Trigger 2 to an input, select that input and
issue the command 247 using the BR-2 or RS232.
Issue command 248 to clear Trigger 2 from that
input.
and sleeve ground.
DC