Daily Use - Electrolux EHF6343FOK User Manual

22 www.electrolux.com
3.4 Residual heat indicator
WARNING!
from residual heat.

4. DAILY USE

WARNING!
Refer to Safety chapters.
4.1 Activating and deactivating
Touch
deactivate the hob.
4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• you do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
4.3 The heat setting
Touch
Touch
There is a risk of burns
for 1 second to activate or
comes on and the hob
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
to increase the heat setting.
to decrease the heat setting.
Touch and at the same time to
deactivate the cooking zone.
4.4 Activating and deactivating
the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone
but do not activate the outer
ring the light that comes out
from the zone may cover the
outer ring. It does not mean
that the outer ring is
activated. To see if the ring is
activated check the indicator.
4.5 Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch until the correct heat
setting comes on. After 3 seconds
comes on.
To deactivate the function: touch
.