Husqvarna P 520DX Operator's Manual page 51

Lubrication overview
9
4
6
7
1. Steering cylinder - front
2. Rear axle splines
3. Control stay
4. Front axle splines
5. Steering cylinder - rear
6. Pedal shaft. Two positions.
7. Lift arms
8. Bearing housing
9. Lift cylinder
Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
1593 - 002 - 22.12.2020
1
8
4
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
To lubricate the articulated steering
joint
1. Lubricate the articulated steering bearing when the
product has all wheels on the ground.
2
3
2
5
CAUTION:
Do not use gasoline or other
petroleum products to clean drive belts.
51