Husqvarna P 520DX Operator's Manual page 19

Hide thumbs Also See for P 520DX:
Table of Contents

Advertisement

Available languages

Available languages

To remove and install the cabin
1. Remove the cabin door. Refer to
install the door on page 20 .
2. Remove the emergency door. Refer to
and install the emergency door on page 20 .
3. Remove the rubber straps and open the engine
cover.
4. Disconnect the battery.
5. Remove the service lid. Refer to
service lid on page 32 .
6. Remove the cover of the fuse box. Refer to
remove the cover of the fuse box on page 32 .
7. Disconnect the cable for cabin control. The cable
has a black plug.
8. Put the rubber grommet in the empty slot.
9. Put a cloth below the hoses for the cabin heat.
Note:
To prevent coolant leakage, make sure that
the cabin heat is off before you disconnect the
hoses.
1593 - 002 - 22.12.2020
To remove and
To remove
To remove the
To
10. Disconnect the hoses for the cabin heat.
11. Remove the 2 screws and the 2 washers behind the
seat (A).
B
12. Remove the screw and the washer behind the hoses
for the cabin heat (B).
13. Remove the screw and the washer at the front of the
door (C).
14. Fold the seat forward.
15. Put 2 straps through the door and the emergency
exit.
16. Put the straps 2 turns through the cabin.
A
C
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

P 525dxP 525dx cabin

Table of Contents