Advertisement
Product description and technical data
Application area
The device is used to screw or loosen screws and bolts. It is also suited for loosening and tightening
nuts in corresponding size.
Technical specifications
Voltage (V)
Frequency (㎐)
Nominal power (W)
Idle speed (rpm)
clockwise
Max. torque (Nm)
counter-clockwise
Square drive (㎜)
Size of included impact wrench sockets (㎜) 17 / 19 / 21 / 22
Weight (㎏)
Cable length (m)
Protection class
Operation
Direction switch
You can change between clockwise and counter-clockwise rotation by pressing the direction switch.
Notes:
•
The direction change may be carried out at a standstill only!
•
Clockwise, the maximum torque is limited to 100 Nm.
Turning on/off
Caution!
Make sure that the supply voltage corresponds to the nominal voltage specified on the type
plate.
Use
•
Press the on/off switch. The device runs at maximum speed. To switch it off, release the on/off
button.
•
The tightening torque depends on the selected speed and the impact period. Use the electric
impact driver when tightening screws and nuts only for pre-assembly. The desired reference
torque of the screw or nut must be achieved with a torque wrench that is set to the reference
torque, not with the electric impact driver.
•
The actual tightening torque must always be checked with a torque wrench!
•
Always follow the manufacturer's instructions for tightening screws or nuts and the manufac-
turer's guidelines for timely and performance-based testing.
•
After a tyre change, regularly check the tyre bolts or nuts. This inspection must be carried out
after 50 to 100 km with a torque wrench.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
230
50
450
3600
100
320
12.7 (½")
2.1
3
II
Item 62552
Page 5
05
2021-1
Advertisement
