Maintenance - Alpha tools ABM 500E Operating Instructions Manual

Anleitung ABM 500 E AlphaTools
GB
the socket by pulling the mains
cable.
Make sure before inserting the
plug that the operating switch is
not locked.
When using a cable drum
uncoil the cable completely.
Cross-section of wire at least
1,5 mm .
2
Do not overload machine.
Secure all workpieces to be
processed sufficiently.
Do not allow children to have
access.
Make sure you have a secure
stance on ladders or scaffold-
ing when using the drill free-
hand.
Localise lines with a line detec-
tor in walls where power, water
or gas lines are laid invisibly.
Wear protection goggles and
use a dust mask for dust-produ-
cing work.
Always arrange for a qualified
electrician to carry out repairs
Use only original replacement
parts
The level of noise at the work-
place may exceed 85 dB(A). In
this case you will need to intro-
duce noise protection measu-
res for the user. The noise
generated by this electric tool
was measured in accordance
with EN 50114-1.
Vibration measured on the
8
04.12.2003 8:34 Uhr
handle acc. to EN 50144-1.

Maintenance

Always keep the drill clean.
Do not use corroding agents for
cleaning plastic.
Check carbon brushes in the
case of excessive sparking.
Keep ventilation channels free.
Seite 8