Whirlpool WFG745H0FE User Instructions page 7

Keypad Feature
CONTROL Oven control
LOCK lockout
hold 3 sec
to lock
SETTINGS Oven use
functions
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners
when control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on
the grate. Do not operate a burner using empty cookware
or without cookware on the grate.
The flame should be adjusted so it does not extend beyond the
edge of the pan.
To Set:
1. Push in and turn knob counterclockwise to IGNITE.
All surface burners will click. Only the burner with the
control knob turned to IGNITE will produce a flame.
2. Turn knob to anywhere between HIGH and LOW.
REMEMBER: When range is in use, the entire cooktop area
may become hot.
Power™ Burner Feature
The front burner is designed to give maximum power when fully
on. It can be used to rapidly bring liquid to a boil and to cook large
quantities of food.
AccuSimmer Burner Feature
®
The AccuSimmer feature allows for more precise simmering
®
and low temperature cooking. It is the right rear burner.
Power Failure
In case of prolonged power failure, the surface burners can
be lit manually. Hold a lit match near a burner, and then turn
knob counterclockwise to IGNITE. After burner lights, turn
knob to setting.
Instructions
No keypads will function with the controls locked.
1. Check that the oven and the timer are off.
2. Press and hold the CONTROL LOCK keypad for 3 seconds.
3. If enabled, a tone will sound, and "CONTROL LOCKED" will be displayed.
4. Repeat to unlock.
Enables you to personalize the audible tones and oven operation to suit your needs.
See the "Oven Use" section."
COOKTOP USE
Sealed Surface Burners
A
B
C
A. Burner cap
B. Burner base
C. Alignment pins
NOTE: The oval burner base is permanently attached to the burner
cap.
IMPORTANT: Do not obstruct the flow of combustion
and ventilation air around the burner grate edges.
Burner Cap: Always keep the burner cap in place when using
a surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas Tube Opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube opening by always using a burner cap.
A
A. 1" to 1
B. Burner ports
Burner Ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
D
D
E
E
D. Igniter
E. Gas tube opening
B
/ " (2.5 cm to 3.8 cm)
1
2
A
B
7