Steam Ironing - UFESA PV0500 Instruction Manual

STEAM IRONING

1
Proceed as described in the "Before first use" section.
2
Set the temperature control (8) to "●●●".
3
The Heater Light (11) will come on.
The light will go off once the required temperature is reached.
4
Set the steam switch (9) in position
●
The iron is ready for use.
Steam burst
When the iron reaches the required temperature and light goes out it is possible to
produce a burst of steam to help iron crumpled fabrics.
1
Press the Steam Burst Button (2) – steam will burst from the holes of the
soleplate.
2
For stubborn wrinkles, wait a few seconds and press Steam Burst button (2) again.
It may be necessary to press the Steam Burst Button a few times
to engage this function.
Do not press the steam burst button when the light is on.
Additional steam can be generated only when the light goes out.
Most wrinkles can be removed within three presses.
STEAM BURST IN VERTICAL POSITION
This function provides extra amount of steam for removing creases from delicate
fabrics in hanging position (hanging curtains or other hanging fabrics).
.