Safety Decals; Disposing Of Machine Fluids - Vanair AIR N ARC RELIANT 150 Series Operations Manual & Parts List

SECTION 1: SAFETY
demonstrated that exposure to power-
frequency electric and magnetic fields is a
human-health hazard." However, studies are
still going forth and evidence continues to be
examined. Until the final conclusions of the
research are reached, you may wish to
minimize your exposure to electromagnetic
fields when welding or cutting.
To reduce magnetic fields in the workplace,
use the following procedures:
1. Keep cables close together by
twisting or taping them.
2. Arrange cables to one side and
away from the operator.
3. Do not coil or drape cables
around your body.
4. Keep welding power source and
cables as far away from
operator as possible.
5. Connect work clamp to workpiece
as close to the weld as possible.
About Pacemakers:
Pacemaker wearers should consult their
doctor before welding or going near welding
operations. If cleared by your doctor, then
following the
recommended.
PAGE - 10
above procedures
090051-OP_r0 (FEB-2014)
1.11

SAFETY DECALS

Safety decals are placed onto, or located
near, system components that can present a
hazard to operators or service personnel. All
pertinent decals listed in Section 7.9, Decal
and Plate Locations are located near a
component, which is subject to respect in
terms of safety precautions. Always heed the
information noted on the safety decals.
DO NOT REMOVE OR COVER ANY
SAFETY DECAL. Replace any safety
decal that becomes damaged or illegible.
1.12 DISPOSING OF
MACHINE FLUIDS
Always dispose of machine fluids under the
guidance of all applicable local, regional and/
or federal law.
Vanair encourages recycling when allowed.
For additional information, consult the fluid
container.
is
®
AIR N ARC 150 SERIES
WARNING
Vanair Manufacturing, Inc.
vanair.com • 800-526-8817