Electrical Connections - Cecilware Turbofast TF-1/2 Installation And Use Manual

eleCtRICal CONNeCtIONS

The oven is setup for operation at the voltage
set forth on the technical data plate.
All ovens are provided with a power cord.
The flexible cable for connection to the electri-
cal mains must not have characteristics which
are less than those of a type with rubber insu-
lation mod. H07RN F and it must have a sec-
tion which corresponds with that set forth in
the section "Technical Data" of the oven. The
cable must also be anchored to the frame with
the cable clamp, the screw of which can be
reached through a hole in the frame. It must
in any case be positioned in such a way that at
no point does it reach a temperature which is
122°F greater than the ambient temperature.
It must be type SJTo plug 20A 250V P section
3xAWG12.
The connection to the electrical line must be
made by placing an automatic switch of suf-
ficient capacity (see "Technical data" of the
oven) and with an opening distance between
8
contacts of at least 3 mm.
Also, during operation of the oven, the power
supply must not vary from the nominal voltage
value by ±10%.
The oven MUSt be earthed by means of the
terminal which carries the earth symbol
on the connection board.
It must also be inserted in an equipotential
system
checked in accordance with current standards)
using the terminal with the equipotential sym-
bol (fig. 6). It is located near the electrical cable
entry on the panel of the oven bottom.
the manufacturer will not be held liable if
this accident prevention standard is not
adhered to.
Fig.5
(the efficiency of which must be