Resolving Ignition Issues; Proper Burner Flame Pattern - Paderno VIDA Essence Series User Manual

Prevention
16
Resolving ignition issues, quick check:
Press the ignition button located on the right side of the control panel or the right shelf fascia (see image A). You should hear a
continuous clicking sound when the button is pressed. If you hear no sound, 1) replace the battery (see image B), 2) check that all wires
are firmly pushed in (see image C).
TIP: WHEN CHECKING THE WIRES THERE ARE TWO COMMON TROUBLE SPOTS TO PAY ATTENTION TO:
1. The two lead wires connected to the ignition button and the electronic ignition module.
2. Check that all wires connected to the electronic ignition module are firmly pushed in.
A
Battery care, use and disposal
DO start by positioning a brand new battery in your
Electronic Ignition Module.
DO remove the battery from the Electronic Ignition
Module during storage periods.
DO recycle or dispose of batteries properly, as per the
requirements of your local municipality.
ATTENTION: ONCE LIT, CONFIRM THAT THE BURNER IS PROPERLY LIT AND THAT THE FLAME PATTERN IS AS DESIRED. IF THE
FLAME PATTERN IS OTHER THAN NORMAL, CONSULT THE TROUBLESHOOTING GUIDE FOR CORRECTIVE ACTION.
D
B
C
HIGH
LOW
4-BURNER MODEL
BG
Small � 3
EE
Large � 2
BG Main electrode - 90 cm
EE Ground wire
BF Main electrode - 50 cm
DF Side burner electrode
DJ Ignition button
DO NOT submerge the Electronic Ignition Module
in water.
DO NOT leave the batteries where a child or pet
could play with or swallow them.

Proper burner flame pattern

The burner flame pattern is the key indicator of proper or improper
function within the cook system. When the burners are performing
correctly you will see a specific flame pattern. All burner ports should
be 2.5 cm/ 1" flame on "HIGH" with orange tips, light blue centre, with
a darker blue flame at the base of the burner port (see image D).
Refer to the troubleshooting section on pages 26–27 if you experience
any of the following issues:
• Large, unruly or irregular orange burner flames.
• The smell of gas in conjunction with irregular flames.
• Low temperatures or uneven heat.
FOLLOW THE BURNER CLEANING PROCEDURE OUTLINED IN THE
MAINTENANCE SECTION (PAGE 23) OF THIS MANUAL OR FOLLOW
THE REGULATOR FLOW LIMITING DEVICE RESET (PAGE 9).
2-BURNER MODEL
BF
Small � 2
DF
DJ
Large � 2
BE Main electrode - 50 cm
DE Ignition Button
BE
BE
DE