Package Contents - HYPERVSN MS Operating Manual

Table 4. Package contents
COMPONENT NAME
Stator+Rotor
Rays
Wall bracket
Remote control (if included)
Screw M2,5x5
Safety bolt
Hexagon 2mm
Philips (PH0) screwdriver
Operating Manual
Tools and fittings required (not supplied)
To assemble and install the Device, the following tools and fittings (that are not supplied
with the Device) are needed:
• Philips (PH2) screwdriver – to assemble the safety bolt.
• Drill – to make holes in a wall, where the Device will be mounted.
Hole diameters:
a) Partitioned walls – 5.3mm,
b) Concrete walls – 5.0mm.
• Fasteners – 3 pieces to attach the wall bracket (M5 mounting hardware,
appropriate for the mounting surface – either a partitioned or a concrete wall).
Attention. This set of tools and fittings listed above are intended for the mounting of
the Device onto the wall bracket supplied with the Device. In the event that the Device
will be installed with another HYPERVSN accessory, see the Operating Manual for these
instructions.
© Copyright 2019 HYPERVSN. All rights reserved
3.

PACKAGE CONTENTS

QUANTITY (# OF PIECES)
1 + 1
4
1
1
4
1
1
1
1
9