Overview Of Device Operating Modes; Operating Modes - HYPERVSN MS Operating Manual

7.

OVERVIEW OF DEVICE OPERATING MODES

Attention. Sections 7.1 - 7.3 are designed for reference only (no action is required at this
stage).

7.1 OPERATING MODES

There are two Device operation modes – the Setup (Hotspot) mode and the Operating
mode.
The modes are selected by the mode switch on the rotor.
Picture 9. Mode switch on the rotor
The "Setup (Hotspot) mode" switch position is marked with a black dot.
Setup (Hotspot) mode
In the Setup (Hotspot) mode the Device creates a wireless network in close proximity to
the Device. The network name is hypervsn-YYXXXXX, where YYXXXXX is a 7-digit
serial number located on the base of the rotor.
In this mode the Device displays the "BEGIN BY UPLOADING YOUR 3D MEDIA" message
(Picture 10), if there is no content uploaded onto the Device or if media playback has
stopped.
Picture 10. Starting message in the Setup (Hotspot) mode
16 © Copyright 2019 HYPERVSN. All rights reserved