HYPERVSN MS Operating Manual page 23

5. Click the arrow
The drop-down menu will appear.
6. Click My Profile
7. Check the data. If it is required to be changed, click Edit profile and edit the data
in the open window.
8. Move the mode switch on the rotor to the Setup (Hotspot) mode position (marked)
(Picture 9).
WARNING! The Device must always be switched off and the rays
completely stationary before you change the mode (move the mode
switches).
9. Turn the Device on again.
10. The Device will start to display the "HYPERVSN" logo. After a few seconds
the "BEGIN BY UPLOADING YOUR 3D MEDIA" and "PLEASE ACTIVATE THE
DEVICE" messages will start to alternate on the Device.
© Copyright 2019 HYPERVSN. All rights reserved
in the right page corner next to your email address.
Picture 19. My Profile command
(Picture 19). The following page will open:
Picture 20. "My Profile" page
Your company name
Your company legal name
Your nickname
example@yourcompany.com
23