Function Selector - Unical Air UND A 9H Instruction Manual

WALL AIR-CONDITIONER
The conditioner is made up of two units connected between themselves through copper pipes (properly insula-
ted) and an electrical power cable.
The indoor unit is installed on the walls of the room to be conditioned.
The outdoor unit is installed on the floor or on the wall on suitable brackets.
Technical data of the air conditioner are printed on the tabels placed on the indoor and outdoor units.
Air intake
grill
Flap
REMOTE CONTROL

FUNCTION SELECTOR

RUN: the conditioner is in stand-by; through remote control it is possible to set the wished working mode.
TEST: the conditioner is in test function; it can be used only by authorized staff during the installation or in
case of troubleshooting.
AUTO: the conditioner is in automatic function; it is possible to switch the conditioner on if the remote control
is not working. For the automatic function see paragraph 2.1.
N:B: There are outdoor units that presents only AUTO and STOP mode.
4
Wall Air-Conditioner
INDOOR UNIT
Air outlet
DISPLAY
Lift the front panel of the unit to reach the manual control of the con-
ditioner.
Positions of the selector:
STOP: the conditioner doesn't receive any signal from the remote
control; it is possible to choose this position in case the conditioner
should remain inactive for a long period.
Air outlet
HEAT COOL SET.
TEMP
OUTDOOR UNIT
RUN DRY
INDICATOR
Air intake
WINDOW
RECEIVER