CHECK PRINTER
The unit has detected that the
printer is not ready to print.
NO PRINTER
The unit can not communicate
with the optional printer.
BATTERY FAIL
The battery voltage has dropped
below the threshold of safe
operation and has shut down in
a safe state*
OR
The battery has been
removed/disconnected.
Alarm message alternates with elapsed
time display
Alarm message alternates with elapsed
time display
22
Check that the printer is not out of labels;
the labels are correctly installed; and the
printer door is fully closed.
The unit was unable to communicate
with the optional printer. Check to make
sure the printer is correctly connected to
the PTS ii, and powered on.
Press 'ON/STANDBY' to shut unit down.
When cuff deflation is required,
disconnect hose to cuff. Ensure that the
battery is connected properly. Plug in AC
power to attempt to recharge the
battery. Service or replace the battery
pack (see Section 3.5 below).