Advertisement
Lightly push up on the front of the paper cover with your thumb and
5
rotate it toward the back of the printer.
Push the tip of the paper into the inlet at the bottom of the paper holder,
6
until the auto-loader catches it and feeds about 10 cm through the paper
cutter.
The printing surface is the outside
of the thermal paper roll
Insertion Slot
Hint
Load the paper in an area protected from direct sunlight. Place the paper on the cover
to make feeding easier.
Press the FEED switch until the paper feeds straight and smoothly.
7
Close the paper cover.
8
Make sure the end of the paper is not inside the cover. Push down on the cover
to lock it into place.
Hints
• When the paper is installed correctly, the OFF LINE lamp stops blinking and the
ON LINE lamp stays lit.
• When the paper is about to run out, red lines appear on both sides of the paper.
Installation Guide
Loading the Printer Paper
3
Advertisement
