Advertisement
1. Casing Instructions
1) Fit two M5 button head screws with star washers in
the bottom of each side panel.
2) Fit right and left hand side panels by locating onto
the hooks on the back plate and pushing downwards.
3) Fix the two side panels to the back lower tabs on the
back plate using two M5 button head screws and star
washers.
4) Fit top panel by sliding latches in the top panel
backwards through holes in the top of the side panels.
2
5) Fix the top panel to the right hand side panel with a
M5 hex bolt and star washer using a spanner. This is for
earth continuity.
6) Slide the key holes slots in the bottom panel over the
screws with star washers fitted earlier in the bottom of
the side panels. Then tighten the screws complete with
star washers to secure the bottom panel
7) Fit the front panel by hooking the latches in the front
panel into the holes at the front of the side panels and
then pushing downwards.
8) Fix the front panels to the lower tabs on the side
panels using two M5 button head screws and star
washers.
Advertisement
