Table of Contents
Advertisement
CONNECTING TO OTHER EQUIPMENT
Windows 2000, Me, 98, 95, NT Workstation 4.0
The Data Transfer Cable can be connected to an IBM PC/AT
or compatible that is equipped with a D-Sub9 RS-232C ter-
minal.
RS-232C terminal
(D-Sub 9-pin)
Macintosh
Connection of the Data Transfer Cable and operation of the
Photo Loader application is not supported on an Apple
Macintosh.
Data Transfer Cable
DIGITAL terminal
CONNECTING TO OTHER EQUIPMENT
IMPORTANT!
• See the documentation that comes with Photo Loader
for information about system requirements.
• Be sure to turn off the camera, computer, and all pe-
ripherals (monitor, disk driver, etc.) connected to the
computer before connecting the digital camera with
the Data Transfer Cable.
• After connecting the camera to the computer, press-
ing down the Power/Function switch, slide it to PLAY
and then turn on the computer. Note that data commu-
nication with a computer is not possible while the
Power/Function switch is in the REC position.
• Never connect or disconnect the cable while Photo
Loader is running. Doing so can cause problems with
program execution, can corrupt data, and can damage
the camera and your computer.
• Data transfer while camera batteries are low can re-
sult in sudden shutdown of the camera. Because of
this, use of the optional AC adapter is recommended
whenever performing data communication with the
camera.
• This camera does not support data communication
with any of the optionally available CASIO PC link
software applications: LK-1, LK-1A, LK-10V, LK-11W,
LK-2, LK-2A, LK-2V, LK-21.
E-107
Advertisement
Table of Contents
