Zanussi ZOHXX2X1 User Manual page 23

3. Close the oven door halfway to the first
opening position. Then lift and pull forward and
remove the door from its seat.
4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
Step 1
1
Before you replace the lamp:
Step 2
6. Pull the door trim to the front to remove it.
7. Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
8. Clean the glass panels with water and soap.
Dry the glass panels carefully. Do not clean the
glass panels in the dishwasher.
When the cleaning is completed, install the glass
panel and the oven door.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel in
the seats correctly.
HOW TO REPLACE: LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the lamp.
A
Step 3
23