Table of Contents
Advertisement
-
Check with a qualified electrician or service representative if you are in doubt whether the appli-
ance is properly earthed.
-
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
please have a qualified electrician to install a proper outlet.
-
If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard.
Do not use the device with a damaged cable or plug.
Start the Dishwasher
The following things should be checked before starting the dishwasher:
-
The dishwasher is level and fixed properly.
-
The inlet valve is open.
-
There is a leakage at the connections of the conducts.
-
The wires are tightly connected.
-
The power is switched on.
-
The inlet and drain hoses are knotted.
-
All packing materials and printings should be taken out from the dishwasher
ATTENTION: After installation, please make sure to keep this manual. The content of this manual
is very helpful to the users.
9. T
ROUBLESHOOTING
Before Calling the Specialist
Reviewing the charts on the following pages may make you be free of calling for service.
Problem
Fuse blown, or the circuit
breaker acted
Dishwasher doesn't
Power supply is not turned
run
on
Water pressure is low
Drain pump doesn't
Overflow
stop
Some sounds are normal
Utensils are not secure in
the baskets or something
small has dropped into the
Noise
basket
Motor hums
Improper detergent
Suds in the tub
Spilled rinse agent
Detergent with colorant was
Stained tub interior
used
Improper program
Dishes and flatware
not clean
Improper basket loading
1. Extremely hard water
2. Low inlet temperature
3. Overloading the dish-
4. Improper loading
Spots and filming on
5. Old or damp powder
glasses and flatware
6. Empty rinse agent dis-
7. Incorrect dosage of
T
IPS
Possible Causes
washer
detergent
penser
detergent
Replace fuse or reset circuit breaker. Remove any other appli-
ances sharing the same circuit with the dishwasher.
Make sure the dishwasher is turned on and the door is closed
securely. Make sure the power cord is properly plugged into the
wall socket.
Check that the water supply is connected properly and the water
is turned on.
The system is designed to detect an overflow. When it does, it
shuts off the circulation pump and turns on the drain pump.
Sound from detergent cup opening.
To ensure everything is secured in the dishwasher
Dishwasher has not been used regularly. If you do not use it
often, remember to set it to fill and pump out every week, which
will help keep the seal moist.
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the dishwasher and let suds evaporate.
Add 4 l of cold water to the tub. Close and latch the dishwasher,
then start a short wash cycle to drain out the water.
Repeat if necessary.
Always wipe up rinse agent spills immediately.
Make sure that the detergent is the one without colorant.
Select a stronger program.
Make sure that the action of the detergent dispenser and spray
arms are not blocked by large dishware.
To remove spots from glassware:
1. Take out all metal utensils out of the dishwasher.
2. Do not add detergent.
3. Choose the longest cycle.
4. Start the dishwasher and allow it to run for about 18 to 22
minutes, then it will be in the main wash.
5. Open the door to pour 2 cups of white vinegar into the bottom
of the dishwasher.
6. Close the door and let the dishwasher complete the cycle.
If the vinegar does not work: Repeat as above, except use 1/4
cup (60 ml) of citric acid crystals instead of vinegar.
18
What To Do
12/2011
Advertisement
Table of Contents
