Table of Contents
Advertisement
How to keep your Dishwasher in Shape
-
After Every Wash
After every wash, turn off the water supply to the
appliance and leave the door slightly open so that
moisture and odours are not trapped inside.
Remove the Plug
-
Before cleaning or performing maintenance, al-
ways remove the plug from the socket.
-
No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the dish-
washer, do not use solvents or abrasive cleaning
products. Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water a n a lit-
tle vinegar, or a cleaning product mad e specifical-
ly for dishwashers.
8. I
NSTALLATION
The dishwasher should not stand on top of the water hoses or the electricity supply cable and the in-
stallation of the pipes and electrical equipments should be done by professionals.
WARNING
Electrical Shock Hazard! Disconnect electrical power before installing dishwasher.
Failure to do so can result in death or electrical shock.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the
sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain
hoses that can be positioned either to the right or the left sides to facilitate proper installation.
The power cord should be easily accessible.
The dishwasher can be installed under a working cover by following the steps of the below picutres.
Leveling the Appliance
Once the appliance is positioned for leveling, the height of the dishwasher may be altered via adjust-
ment of the screwing level of the feet. In any case, the appliance should not be inclined more than 2° .
The max. adjusting height of the feet is 20 mm.
If the appliance is leveled correctly, it will be more stable and much less likely to move or cause vibra-
tions and noise while it is operation.
Water Connection
The water pressure must be between 0.04 MPa and 1 MPa. Is the pressure lower or higher pls. con-
tact a technical specialist.
Cold Water Connection
ACHTUNG: The appliance is to be connected to the water mains using new hose sets and that
old hose-sets should not be reused.
I
NSTRUCTION
-
When not in Use for a Long Time
It is recommend that you run a was h cycle with
the dishwasher empty and the n remove the plug
from the socket, turn off the water supply and
leave the door of the appliance slightly open. This
will help the door seals to last longer and prevent
odours from forming within the appliance.
-
Moving the Appliance
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
-
Seals
One of the factors that cause odours to form in the
dishwasher is food that remains trapped in the
seals. Periodic cleaning with a damp sponge will
prevent this from occurring.
16
12/2011
Advertisement
Table of Contents
