Table of Contents
Advertisement
6. S
P
TARTING A
ROGRAM
Cycle Table
Cycle Selection In-
Program
formation
For the heaviest soiled
loads, such as pots,
pans, casserole dishes
and dishes that have
Intensive
been sitting with dried
food on them for a
while.
For
normally
loads, such as pots,
plates,
glasses
Normal
lightly
soiled
(*EN 50242)
standard daily cycle.
A
shorter
lightly soiled loads that
Rapid
do not need drying.
NOTE: *EN 50242: this program is the test cycle.
The information for comparability test in accordance with EN 50242, as follows:
-
Capacity: 12 settings
-
Position upper basket: upper wheels on rails
-
Rinse aid setting: 5
-
The power consumption: off-mode
Starting a Cycle
-
Draw out the lower and upper basket, load the dishes and push them back. It is commended to
load the lower basket first, then the upper one (see section "Loading the Baskets").
-
Pour in the detergent (see section "Salt, Detergent and Rinse Aid").
-
Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
-
Close the door, press the ON/OFF button and the ON/OFF lamp will turn on.
-
Press the program button, the program will be changed in the following direction:
Intensive>Normal>Rapid
If a program is selected, the response lamp will light.
-
Then press the Start/Pause button, the dishwasher begins to start.
NOTE: A click could be heard when the door is closed perfectly.
Program Change
Premise:
-
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise
the detergent may have already been released and the appliance may have already drained the
wash water. If this is the case, the detergent dispenser must be refilled (see section "Fill in the De-
tergent").
-
Pls. press the on/off button to cancel the program, press the on/off button to restart the machine,
select the new program and press the start/pause button.
-
The program lamps shows the state of the dishwasher:
a) all program lamps off_ _ _ _ _ _ _ _ _ _ _ _ _ _ _program finished
b) one of the program lamp on_ _ _ _ _ _ _ _ _ _ _ _cycle running
c) one of the program lamp blinking_ _ _ _ _ _ _ _ _ _pause
NOTE: If you open the door when washing, the machine pauses and warning alarm rings.
When you close the door, the machine will keep on working after 10 seconds.
Description of
Cycle
Pre-wash
Main wash (60° C)
Rinse
Rinse2
Hot rinse
Drying
soiled
Pre-wash Rinse
Main wash (46° C)
and
Rinse
pans,
Hot rinse
Drying
wash
for
Main wash (40° C)
Hot rinse
left-on mode:
Running
Detergent
Pre/main
5/25 g
(or Tablets w/o
the addition of
rinse aid)
5/25 g
(or Tablets w/o
the addition of
rinse aid)
15 g
0.39 W
0.50 W
13
Energy
Water
Time
(kWh)
(Min.)
180
1.30
162
1.03
39
0.50
(l)
16
13
7
12/2011
Advertisement
Table of Contents
