Advertisement
Binding your T8 Lite
Bind mode for D8 protocol receivers
1. Turn on the transmitter and keep the throttle at its lowest position. Press and
hold the bind button for longer than 1 second, the transmitter will start beeping in
a beep-beep-beep pattern, signaling D8 mode. If the transmitter beeps in a beep
（x2）-beep(x2)-beep(x2) pattern, this means the transmitter is in D16 mode
and the bind button should be pressed momentarily to return to D8 mode.
2. Power on the receiver, press the bind button on the receiver within 3 seconds
to enter bind mode on the receiver.
3. The red light on the receiver will flash, signaling that the unit has bound
successfully. Turn the receiver off and on again for the unit to function correctly.
Note: D8 receivers made by different manufacturers may have different binding
procedures. Refer to the user manual for precise binding instructions.
Bind mode for D16 protocol receivers
1. Turn on the transmitter and keep the throttle at its lowest position. Press and
hold the bind button for longer than 1 second, the transmitter will start beeping in
a beep(x2)-beep(x2)-beep(x2) pattern, signaling D16 mode. If the transmitter
beeps in a beep-beep-beep pattern, this means the transmitter is in D8 mode
and the bind button should be pressed momentarily to return to D16 mode.
2. Power on the receiver, press the bind button on the receiver within 3 seconds
to enter bind mode on the receiver.
3. The red light on the receiver will flash, signaling that the unit has bound
successfully. Turn the receiver off and on again for the unit to function correctly.
Note: D16 receivers made by different manufacturers may have different binding
procedures. Refer to the user manual for precise binding instructions.
Specifications
Size: 160*130*45mm
Weight: 218g
Frequency: 2.400GHZ-2.480GHZ
RF Module: Multi-Protocol Module Compatible Single chip(CC2500)
Protocol Options: D8/D16
Transmission power: 20dbm
Antenna gain: 2db
Range:~1km @ 20dbm (depending on the receiver)
Battery: Built in 3.7v 1000mah Lithium battery
Charging: Built in USB-C charging
Channels: Up to 8 channels (depending on the model / receiver)
Gimbal: High-precision potentiometer sensor gimbal
4
Advertisement
