Installation; Connecting To A Computer - Canon LV-S3 Owner's Manual

Installation

Connecting to a Computer

IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Note :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet. Turn the projector and peripheral
equipment on before the computer is
switched on.
Cables used for connection
• VGA Cable ( HDB 15 pin )
• Audio Cable ( Mini Plug (stereo) ) ✽
• USB Cable ✽
• MAC Adapter ( For Macintosh ) ✽
✽ Not supplied.
Monitor Output Audio Output
Audio Cable
VGA Cable
(Stereo) ✽
RESET S-VIDEO IN
VIDEO IN
RGB IN /
COMPUTER /
COMPONENT IN
COMPONENT
AUDIO IN
Terminals of the Projector
USB port
If you wish to use Page LM buttons on
USB
✽
Cable
the remote control unit, connect USB port
of your computer to the USB socket of the
projector with a USB cable. (
When using the provided Presentation
Remote Receiver, this connection is not
necessary.
SERVICE PORT
AUDIO
IN
N MAC ADAPTER (Not supplied)
A Macintosh adapter may be required when you use a
Macintosh computer.
Set switches as shown in the
table below depending on RES-
OLUTION MODE that you want
to use before you turn on pro-
jector and computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
P10, P38 )
✽
ON
ON DIP
1 2 3 4 5 6
OFF
1 2 3 4 5 6
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON ON ON OFF OFF
15